NRS250 Honda engine wear reversed configuration

SLR ever load of small leaks from honda NRS250 which will be deployed in moto3, Namely the possibility of a spec engine and also the form that will be used honda engine. Honda reportedly wearing a strange configuration that is overturned position exhaust with trotle-body, which usually are in front of the engine exhaust while trotle-body behind the head engine, now in the NRS is really different, see picture below:

flashlight and inverted position of the engine

Why SLR dare to guess if it's true honda engine configuration using reverse this ... because of the images and pictures realnya sketnya already be comparable, see once again the picture above and below, there is a red circle and green, the engine looks the same form of the bulge, so the sketch of that picture memangbenar. See also the form of exhaust pipes, a circular from the rear toward the future and then directed down the engine, as well as terliahat in the original picture. sketches so it was true, with an inverted engine.

look at the engine, similar to the picture sketched above

The question now, why did Honda make this inverted-shaped machine,? reason is the placement machine seibang mass, so that motor control would be easy. in the 125cc engine 2tak, the placement machine is fairly easy because the shape of Gp125 machine is small and low. different 4tak 250cc engine has a great shape and height, according to desauner honda, the only way to balance the motor weight is by turning the machine direction streaks a few degrees past the vertical line, once again see the picture (red machine) that its placement was directly motor center in the middle.
In addition, the muffler is concealed under the machine, bro already taukan how the weight of exhaust 4tak, with the engine placed under the weight of the exhaust would also be located further and further down into the center of grapitasi, again aiming to increase the stability of the motor itself.